战争前线进入时出现 Error Failed toinitialize the game‘s start up_百度知道
楼主是买的正版还是网上下载的？如果用的是360安全卫士和360杀毒，建议先关掉，然后重新运行，如果不行的话，重新安装一遍。如果是免安装版，那就重新下载一遍，如果还不行，那就是硬件或者驱动和flash x的问题了。没有详细描述情况，只有把所有情况都考虑一遍了，祝问题解决，游戏愉快，记得给分哦。
我想说：你TM的有病吧？战争前线是网游，不懂就别TM乱说，就在那装13
S B，你敢说你知道所有的游戏？不详细说明就在那BB，你当你是小蜜蜂啊，S B，懂什么叫做按照一般情况考虑不？二 货，滚蛋。
您可能关注的推广
等待您来回答
下载知道APP
随时随地咨询
出门在外也不愁ISL97522IRZ-T (INTERSIL) PDF技术资料下载
ISL97522IRZ-T 供应信息 IC Datasheet 数据表 (16/20 页)
按型号查询：
ISL97522IRZ-T
4通道的TFT -LCD供应
&[4-Channel TFT-LCD Supply]
型号：&&ISL97522IRZ-TPDF文件：
鼠标右键选目标另存为
不需安装PDF阅读软件
需安装PDF阅读软件
4通道的TFT -LCD供应[4-Channel TFT-LCD Supply]
文件大小：&&416 KPDF页数：
&&20 页联系供应商：&& 品牌Logo:
&&&&INTERSIL [ INTERSIL CORPORATION ]
ISL97522IRZ-T&&
ISL97522IRZ-T&&
ISL97522IRZ-T&&
√ 欧美㊣品&
ISL97522IRZ-T&&
中文翻译版 (新)
ISL97522Buck InductorAn inductor value in the range 3.3-10uH is recommended forthe buck converter. Besides the inductance, the DCresistance and the saturation current should also beconsidered when choosing buck inductor. Low DCresistance can help maintain high efficiency, and thesaturation current rating should be at least maximum outputcurrent plus half of ripple current.Buck MOSFETThe principle to select Buck MOSFET is similar to that ofBoost. The voltage of stress of buck converter should bemaximum input voltage plus reasonable margin, and thecurrent rating should be over the maximum output current.The rDS(ON)of this MOSFET should be in the range from20mΩ to 50mΩ.Rectifier Diode (Buck Converter)A Schottky diode is recommended due to fast recovery andlow forward voltage. The reverse voltage rating should behigher than the maximum input voltage. The average currentshould be as the following equation,IAVG=(1–D)*IO(EQ. 19)minimum load can be adjusted by the feedback resistorsto FBL.The bootstrap capacitor can only be charged when thehigher side MOSFET is off. If the load is too light which cannot make the on time of the low side diode be sufficient toreplenish the boot strap capacitor, the MOSFET can’t turnon. Hence there is minimum load requirement to charge thebootstrap capacitor properly.Start-Up SequenceFigure 21 shows a detailed start-up sequence waveform. Fora successful power-up, there should be six peaks at VCDLY.When a fault is detected, the device will latch off until eitherEN is toggled or the input supply is recycled.If EN is L, the device is powered down. If EN is H, and theinput voltage (VIN) exceeds 2.5V, an internal current sourcestarts to charge CDLYto an upper threshold using a fastramp followed by a slow ramp. If EN is low at this point, theCDLYramp will be delayed until EN goes high.The first four ramps on CDLY(two up, two down) are used toinitialize the fault protection switch and to check whetherthere is a fault condition on CDLYor VREF. If a fault isdetected, the outputs and the input protection will turn offand the chip will power down.If no fault is found, CCDLYcontinues ramping up and downuntil the sequence is completed.During the second ramp, the device checks the status ofVREFand over temperature.Initially the boost is not enabled so VBOOSTrises to VIN-VDIODEthrough the output diode. Hence, there is a step atVBOOSTduring this part of the start-up sequence. If this stepis not desirable, an external PMOS FET can be used to delaythe output until the boost is enabled internally. The delayedoutput appears at AVDD.VBOOSTsoft-starts at the beginning of the third ramp. Thesoft-start ramp depends on the value of the CDLYcapacitor.For CDLYof 220nF, the soft-start time is ~2ms.VOFFturns on at the start of the fourth peak. At the fifthpeak, the open drain o/p DELB goes low to turn on theexternal PMOS Q3 to generate a delayed VBOOSToutput.VONis enabled at the beginning of the sixth ramp. AVDD,VOFF, DELB and VONare checked at end of this ramp.Vlogic’s start-up is controlled by ENL. When ENL is L, Vlogicis off, and when ENL is H, VLOGICis on.Where IOis the output current of buck converter.Output Capacitor (Buck Converter)Four 10uF or two 22uF ceramic capacitors arerecommended for this part. The overshoot and undershootwill be reduced with more capacitance, but the recovery timewill be longer.PI Loop Compensation (Buck Converter)The buck converter of ISL97522 can be compensated by aRC network connected from CINTL pin to ground. C27 =4.7nF and R17= 2k RC network is used in the demo board.The larger value resistor can lower the transient overshoot,however, at the expense of stability of the loop.The stability can be optimized in a similar manner to thatdescribed in the section on &PI Loop Compensation (BoostConverter)”.Bootstrap Capacitor (C28)This capacitor is used to provide the supply to the high drivercircuitry for the buck MOSFET. The bootstrap supply isformed by an internal diode and capacitor combination. A1uF is recommended for ISL97522. A low value capacitorcan lead to overcharging and in turn damage the part.If the load is too light, the on-time of the low side diode maybe insufficient to replenish the bootstrap capacitor voltage. Inthis case, if VIN-VBUCK& 1.5V, the internal MOSFET pull-updevice may be unable to turn-on until VLOGICfalls. Hence,there is a minimum load requirement in this case. The16FN7445.0December 13, 2006后使用快捷导航没有帐号？
查看: 1798|回复: 5
最后登录QQ注册时间阅读权限10精华0积分20帖子
QQ小野人, 积分 20, 距离下一级还需 30 积分
最后登录QQ注册时间阅读权限20精华0积分4673帖子
春天到了，到处都是野花。。。
咕噜队长, 积分 4673, 距离下一级还需 327 积分
窗口初始化失败& &重新安装客户端
最后登录QQ注册时间阅读权限10精华0积分25帖子
QQ小野人, 积分 25, 距离下一级还需 25 积分
现在这个游戏很让人恼火的，很卡，很卡，已经有3..4天了也解决不掉，而且已经开始有外挂出现了，嗨，腾讯的所有东西都是这样，还在内测的时候外挂基本上已经满天飞了，真不知道是在测试游戏还是在测试外挂。。。
最后登录注册时间阅读权限200精华0积分167982帖子
白银骑士, 积分 167982, 距离下一级还需 32018 积分
「情何以堪」 发表于
窗口初始化失败& &重新安装客户端
战争前线常见问题ＦＡＱ
q：failedtoinitializethegamestartupinterface 游戏中出现这个怎么办。
a：先卸载游戏，去c盘找到管理员账号登陆的我的文档（比如我安装游戏是在admin这个账号下的，我就去admin账号下的我的文档），删除掉mygame这个文件夹当中战争前线的所有资料。去我的文档这个文件夹，找到保存的游戏这个文件夹，删除掉mygame这个文件夹中战争前线所有的资料。重新启动电脑。重新安装游戏客户端。
最后登录QQ注册时间阅读权限0精华2积分7370帖子
提示: 作者被禁止或删除 内容自动屏蔽
[/size=7]除暴安良是我做市民的责任，而行善积德也是我本身的兴趣
最后登录QQ注册时间阅读权限20精华0积分4673帖子
春天到了，到处都是野花。。。
咕噜队长, 积分 4673, 距离下一级还需 327 积分
天歌 发表于
战争前线常见问题ＦＡＱ
http://wf./forum.php?mod=viewthread&tid=6232&fromuid=446892
了解&&下次一定OK
Powered by我调了战争前线分辨率怎么进不了游戏说什么failed to intialize the game sta_百度知道
我调了战争前线分辨率怎么进不了游戏说什么failed to intialize the game sta
大神.你在那调的啊.如果是在游戏文件乱调的.备份这个文件删之.如果在游戏里调的我就那闷了你怎么做的啊?游戏里都能把游戏搞坏.
其他类似问题
按默认排序
其他1条回答
进了游戏把所有调为最低，你要是在外面乱调，跟楼上说的样游戏都能搞坏
战争前线的相关知识
您可能关注的推广
等待您来回答
下载知道APP
随时随地咨询
出门在外也不愁